ajax load

Bell & Gossett - SU-105-4

Bell & Gossett Heat Exchanger SU-105-4 Bell & Gossett heat exchanger steam in the shell, water in the tubes. Model #SU-105-4, 10"shell diameter, 60" length, 4-pass. Tubeside pressure 125lbs, test pressure in tubes 300lbs, cast iron head, steel tube sheet, shell is steel, tubes are 3/4" O.D. copper. Bell & Gossett "SU" heat exchanger is an instantaneous type, designed to heat liquids with steam. These units can be connected to any steam boiler or system. The capacity of the boiler should be checked to be sure that it is sufficient to handle the load imposed by the heat exchanger. Some method of controlling the steam flow to the heat exchanger should be installed according to the manufacturers directions. "SU" heat exchangers are available in 2, 4 or 6 pass construction with lenghts up to 10 feet and shell diameters through 30 inches. Unless you are replacing an existing same model unit, selection for new installation may require speaking to one of our sales consultants. You will need to know the following conditions: 1. Water flow in the tubes (Gallons per minute). 2. Water temperature in and out F., 3. Steam pressure at the unit.
SU-105-4 - Bell & Gossett
Manufacturer Bell & Gossett
Part Number 10"
Shell Diameter 60"
Length 4-Pass
Weight 322.00 lbs
$6,675.76
Quantity
Manufacturer Bell & Gossett
Part Number 10"
Shell Diameter 60"
Length 4-Pass
Weight 322.00 lbs
$6,675.76
Quantity
GO BACK
ADD TO CART
cart pullout top
shopping cart
cart pullout bottom
PRODUCTQTYPRICE
0
$ 0.00
shopping cart CHECKOUT